MK2 Golf / Jetta / GTI - How To Remove The Battery

  • Category: Electical Electrical
  • Difficulty: Easy Easy
  • Author: DIYJus
  • Date Submitted: 2006.12.24
  • Date Updated: 2007.02.25
  • Version: 1.1

Overview

  • This DIY will explain the procedure for removing the battery on a MKII Golf, Jetta or GTI.
  • Note: You will lose power to the entire car! This means that you'll lose your radio settings, the clock will go off, the MFA will lose the mileage, MPG, etc. If your radio requires a code to operate be SURE to have it ready before you disconnect the power.

Tools

VW MK2 battery removal tools

Here's a list of recommended tools to complete this job:

1) 13mm 3/8" drive socket
2) 10mm open-ended wrench
3) 3/8" drive ratchet
4) 10" 3/8" drive extension bar

Parts

This job shouldn't require any parts. :-)

Instructions

DISCLAIMER: No warranty or guarantee is provided for the information provided on this site; you use it at your own risk. Although contributors to DIYNexus have an impressive depth of knowledge, neither they, nor DIYNexus can be held liable for any technical inaccuracies, typographical errors or consequences from the use of this information. Depending on the project, it is possible to void your factory warranty, disable a safety feature, create a hazardous condition, be injured or killed. :-( If you are uncomfortable or inexperienced working with anything described on this site, please consider having the work done professionally.

  • VW MK2 battery location1) Open the hood and locate the battery on the driver's-side of the engine bay near the front of the car.
  • VW MK2 battery terminal2) Using the 10mm wrench, loosen the nuts on the positive and negative terminals.
  • VW MK2 battery terminal removal3) Once loosened, pull the negative terminal straight up off the battery terminal post (sometimes it helps to twist) and place it behind the battery. Repeat with the positive terminal.

    Thanks to jbx2 from the 'tex for the safety tip to remove the negative terminal first. This prevents accidental shorting to the chassis when removing the positive terminal.
  • VW MK2 battery clamp4) Now we need to locate the battery hold-down clamp bolt. It's down at the base of the front of the battery.
  • VW MK2 battery clamp removal5) Using the ratchet, extension and socket, remove the bolt and clamp. Note the orientation of the clamp so that you know how to reinstall it later! Often times these are rusty, dirty or corroded. Consider cleaning them with a wire brush and painting them to prevent further deterioration. Also, I always use anti-seize on the threads of this bolt when reinstalling it.
  • VW MK2 battery removal6) Here's the hardest part. To remove the battery, first you need to slide it towards the front of the car slightly to disengage it from the rear clamp. (You can't really see the clamp now, but it will become clear after the battery is out) After you've slid it forward about 1/2 an inch, you can lift it up and slightly towards the passenger's side of the car to clear all the obstructions. (If your MKII doesn't have power steering, it'll be a lot easier for you!) Once you've cleared everything, simply take the battery out. Of course, be careful not to tip the battery too far from level or it may leak. If you're keeping this battery, I suggest you wash it off with a damp cloth to remove any dirt/acid residue. Be sure to get the bottom as well!
  • VW MK2 battery tray7) You've done it! With the battery removed you can see that rear clamp that holds on the back of the battery. You can also see all the accumulated dirt, leaves and nastiness that seems to somehow make a home there. :-)
  • 8) If you want to reinstall this battery or a new one, you basically need to reverse these steps. Be careful to put the battery back in, then slide it back about 1/2 an inch, and slide it left to right a little while pushing back. This should get you back in that rear catch. Then reinstall the bracket and bolt. Finally, reinstall the terminals (positive first, then negative) and tighten them.